Real-time tracking wired vehicle GPS tracker with collision alarm system MT009

Short Description:

MT-009 Introduction MT-009 Instruction manual Characteristic parameter Property description Content Specifications Terminal size 76.6mm*27.1mm*15 weight 75g network GSM/GPRS Network frequency band 850/900/1800/1900Mhz GPS module UBLOX GPS sensitivity -159dBm GPS position accuracy 10m First positioning time  Cold start  35-80s Warm start  35s Hot start 1s working voltage 9-100V Storage temperature -40°C to +85°C ...


  • Min.Order Quantity: 10 Piece/Pieces
  • Supply Ability: 30000 Pieces per Month
  • Port: Shenzhen, China
  • Payment Terms: L/C,D/A,D/P,T/T
  • Product Detail

    Product Tags

    MT009 tracker Function
    MT009 tracker Light alarm
    Quadro

    Characteristic parameter

    Property

    description

    Content

    Specifications

    Terminal size

    76.6mm*27.1mm*15

    weight

    75g

    network

    GSM/GPRS

    Network frequency band

    850/900/1800/1900Mhz

    GPS module

    UBLOX

    GPS sensitivity

    -159dBm

    GPS position accuracy

    10m

    First positioning time

     Cold start  35-80s

    Warm start  35s

    Hot start 1s

    working voltage

    9-100V

    Storage temperature

    -40°C to +85°C

    working temperature

    -20°C to +55°C

    humidity

    5%--95% Non freezing

    Function

    function

    Function breakdown

    description

    Location data report

    Location tracking

    The positioning information such as latitude and longitude is returned according to the set interval time.

    Vehicle status detection

    Ignition/extinguish state

    The ACC switch status is included in each uploaded packet.

    Vehicle power failure reminder

    Turn on the backup battery. When the host detects that the vehicle voltage is less than 5V, it will report the power failure reminder.

    Low pressure alarm

    When the host detects the vehicle voltage 5-10V, it reports a low-voltage alarm reminder.

    Over Speed alarm

    The platform sets the maximum speed limit value. When the GPS speed is greater than the set value, the overspeed alarm is reported.

    Oil line detection

    Support platform and SMS to cut off oil and gas, oil and gas function

    Illegal removal of the alarm

    When the terminal generates a power failure alarm or triggers the light status, if both conditions are generated within 2 minutes, the illegal removal alarm is reported.

    Other Functions

    Blind zone re-transmission function

    The terminal is located and not online, and the data is stored up to 300. Upload when the signal is online normally

    EPO assisted positioning function

    The terminal supports the EPO assisted positioning function to enhance the positioning effect.

    Inflection point

    When the device orientation angle changes more than a certain angle, immediately upload a position data to optimize the trajectory.

    Remote upgrade

    Upgrade the housekeeper remote upgrade.

    Low power consumption

    Sleep mode

    G-sensor senses the vibration state of the vehicle in real time, and the power is in the sport mode. When the host has no vibration for 5 minutes, it enters the static mode, and the GPS module is turned off, and the vibration enters the sport mode.

    MT009 Host interface
    MT009 wire thoery

    Interface Definition

    Property

    color

    description

    1

    Yellow

    Oil road negative

    2

    Orange

    ACC

    3

    Black

    battery negative

    4

    Red

    battery positive

    1. Relay white wire connected to the battery positive

    2. Relay yellow wire is connected to the position yellow line

    3. The two green wires of the relay are respectively connected to the oil pump line (the oil pump line needs to be disconnected). The direct the red line without the relay is connected to the positive pole of the battery, and the negative line of the black line can be used.

    Matters needing attention in equipment wiring

    a. power supply, ACC, oil and electricity control line (4Pin)

     

    b. the equipment standard power supply for 12V-100VDC power line, please use the original offer, the red line for the positive power supply, black for the cathode of the power supply; please choose the cathode of the power supply grounding alone or ground installation, not with other ground together;

    c. equipment orange line to the ACC line, be sure to pick the ACC vehicle terminal will switch, according to the ACC state to determine whether to enter the fortification; if no ACC line will allow vehicles to enter the default fortification state, vehicle vibration occurs, will trigger a vibration alarm. If the anti-theft function is not needed, the ACC line can be directly connected with the positive pole of the power supply.

    d. break the oil and electricity control line (yellow line) to connect the yellow line on the relay.


  • Previous:
  • Next: