OEM Supply Fleet Online Solutions - obd connector OBD GPS Tracker OBD-Y07 – Dragon Bridge
OEM Supply Fleet Online Solutions - obd connector OBD GPS Tracker OBD-Y07 – Dragon Bridge Detail:
Traffic network examination instrument
Working voltage: DC6V~20V
Working current: <55mA@13.7V
Maximum current: <120mA @13.7V
Standby current: 6mA@12.2V
Maximum power consumption: <2W
Start mode: engine ignition
Working temperature: -20 ° C ~ 85 ° C
Working humidity: 10% to 90%
One way voltage output;
One way voltage input;
Two-way CAN bus interface;
One way K bus interface;
One way lin bus interface;
One way serial port;
Seven-way output control;
Two-way input detection;
Two-way CAN transceiver chips are respectively two high-speed CAN transceivers and their auxiliary circuits;
One way serial transceiver chip;
One way K transceiver;
One way lin bus transceiver
Power chip and auxiliary circuit;
CPU and auxiliary circuits;
G-SENSOR and its associated circuits;
GPRS module parameters:
1. Quad frequency: 850/900/1800/1900 MHz
2, GPRS multi-time slot: Class 12
3. GPRS mobile station: Class B
4. Compatible with GSM Phase 2/2+: Class 4 (2W @ 850/900MHz) Class 1 (1W @ 1800/1900MHz)
5. Rate: GPRS Class 10 85.6 kbps (downstream) 42.8 kbps (upstream)
6, support PBCCH
7, coding scheme: CS 1, 2, 3, 4
9, the protocol stack: TCP / UDP / PPP / HTTP * / SMTP *
10, current consumption: 1.3mA @ DRX=5 1.1mA @ DRX=9 (TBD)
11, SIM application kit
12, AT command control: GSM 07.07, 07.05 and other AT extension instructions
13, support for Bluetooth
The main parameters of the acceleration sensor:
Measuring acceleration range: ±4g
Measurement accuracy: 8.192mg
Support collision, rapid acceleration, rapid deceleration, sharp turn monitoring
GPS module main parameters:
Receiver type: GPS1612
GPS and QZSS L1 C/A, 1
Hardware support Galileo E1B/C, Compass
SBAS: WAAS, EGNOS, MSAS Accuracy: 2D plane: GPS 10 m average
2D plane: 5m average with WAAS assistance
Timing accuracy: 1us capture: cold start <42 s
Warm start <36s
Hot start <1s
Device sleep function: When the vehicle goes out of flame and exceeds the set sleep time (time, the host computer can be configured), the device will enter the sleep state until the next bus has data or low pulse signal, the device will be woken up. After judging that the vehicle is turned off, it is no longer a direct power off, but enters the sleep mode and periodically reports the device health message.
RTC time function: With RTC (real-time clock) function, it can provide accurate time and provide time stamps (such as driving behavior messages, collision messages, etc.) for various messages.
There are several ways to get the real-time clock, and you can correct it by sending instructions from the server.
Intercept function: It can remotely issue interception commands, so that the vehicle can not be fired next time to achieve anti-theft or disable purposes.
Switch lock function: It can remotely issue the unlock command to enable the vehicle to open the central lock remotely. It is possible to remotely issue a lockout command (first to judge the door and close the trunk) so that the vehicle can close the central lock.
Remote car search: The remote car search function is realized by the device to control and read the bus data. The remote car search system realizes the remote car search function by remotely controlling the headlights or speakers of the vehicle.
Remaining battery reading function: It can read the remaining battery capacity of most models.
GPS positioning function: support GPS function, and optimize GPS anti-jamming and antenna to achieve fast GPS positioning. The reporting interval of the terminal can be set through the network, and the positioning information is uploaded to the server, and the server performs various data applications according to the uploaded GPS message, such as a track, a location, an electronic fence, and the like.
Curve compensation function: Generally, we set the GPS interval to a fixed value of 10S, but when encountering a curve or a bridge, there will be a trajectory directly crossing the road or bridge hole at the display end, which makes the user experience worse. In order to balance the accuracy of the trajectory and the data flow, the GPS reporting interval uses a preset value when traveling in a straight line. When encountering a curve, the curve compensation technique is adopted to increase the reporting density of the GPS point, so that the display end is more Attach the road surface and enhance the user’s physical examination.
Low-voltage alarm function: When the vehicle battery power is lower than a certain set value, a low-voltage alarm will occur, indicating that the owner’s battery is low. The usage scenario of the low-voltage alarm is the working state of the device and is detected each time a health message is sent.
Driving behavior analysis: The product has built-in acceleration sensor, which can detect the rapid acceleration, rapid deceleration, and sharp turn of the vehicle. When the vehicle has a bad driving behavior such as sudden increase, sudden decrease, sharp turn, etc., the device will generate a posture message. The actual driving behavior, time, and location information generated are reported to the server for analysis of the driving behavior of the owner.
Collision alarm and filtering function:
When the vehicle generates a collision behavior during driving, the built-in acceleration sensor generates a collision value, and the device generates a collision message, and packages the collision value with the position information and time of the collision to upload to the server. The server will push rescue information to the service station for collision alarms. The product adds collision filtering logic. When it is judged by logic that a real collision occurs, the rescue information will be pushed to the service station, and the misjudgment generated by the filtering will be generated.
External serial port expansion
Function description: The external serial port is expanded, and one channel is reserved, which is convenient for connection with other external devices and expands the product form.
Product detail pictures:
Related Product Guide:
California to become the first state to test digital license plates | Fleet Management System Features
Lytx DriveCam Enterprise Review & Rating | Is My Car Being Tracked By Gps
We have been convinced that with joint attempts, the business enterprise between us will bring us mutual benefits. We could guarantee you product or service good quality and aggressive value for OEM Supply Fleet Online Solutions - obd connector OBD GPS Tracker OBD-Y07 – Dragon Bridge, The product will supply to all over the world, such as: Armenia , Monaco , Myanmar , Taking the core concept of "to be the Responsible". We will redound up on society for high quality products and good service. We will initiative to participate in international competition to be a first- class manufacturer of this product in the world.
By Mike from Lithuania - 2016.04.18 16:45
The manufacturer gave us a big discount under the premise of ensuring the quality of products, thank you very much, we will select this company again.
By Elsa from Hungary - 2015.10.01 14:14